Slicing With 0.4mm Nozzle
Changing to L3 Level Strength
for 0.4mm Nozzle
- By default, OWLplane uses 0.32mm extrusion width and 0.17mm layer height which may not good to use with 0.4mm Nozzle (Strength Level1, see Strength Level Code Table).
- The Solutin is to use Strength Level3 instead where Extrusion width is set to 0.42 and layer height is set to 0.25mm with extrusion multiplier set to 102%.
- If your print result is not strong enough, try to change the layer height to 0.2mm instead. Please note that it will increase your total weight.
- Please watch the following video how to change the parameters:
Please learn the above video on how to slice STL files.